Filter
Top Products
Operating Instructions
Safety InstructionsInstallation InstructionsTroubleshooting TipsConsumer Support
Installation of the downdraft system.
Read these instructions completely and carefully.
30
″
Cooktops/Downdraft Unit JVB37
NOTE: Before you begin: Measure and mark Dimension 3 to ensure that adequate flat countertop
surface is available.
■ Identify the cutout illustration for the cooktop
model you are installing with this downdraft vent.
■–Draw lines on the countertop to follow as a cutting
guide.
■–Make sure sides of the opening are parallel and
rear and front cuts are exactly perpendicular to sides.
Planning Installation 30” Electric & Gas Cooktops with Downdraft Vents Preparing Cutout
Cooktop Surface Surface Depth Minimum Setback Combined Cutout Combined Cutout
Model No.
Overall Width Overall Depth with Downdraft Cutout to Front Edge Width Depth
JP326 30-1/4″ 21-1/4″ 23-3/8″ 2-1/2″ 28-1/2″ 22-3/8″
JP340 29-3/4″ 20-7/8″ 23″ 2-1/2″ 28-1/2″ 22-1/4″
JP350
JP360
JP930
JP938
JP350SC 29-7/8″ 21-1/2″ 23-5/8″ 2-1/2″ 28-1/2″ 22-9/16″
JP930SC
JP938SC
JGP328 30″ 21″ 23-1/8″ 2-1/2″ 28-1/2″ 22-5/16″
JGP933
JGP336 30″ 21″ 23-1/8″ 3-1/4″ 28-1/2″ 22-1/8″
JGP932 29-3/4″ 21″ 23-1/8″ 2-1/2″ 28-1/2″ 22-5/16″
JGP932S 29-7/8″ 21-5/8″ 23-3/4″ 2-1/2″ 28-1/2″ 22-5/8″
10
2
1
⁄8″
8
1
⁄2″