Filter
Top Products
– 15 –
Interior Light
Resistance through the interior light from the
CN02 pin 7 to the power cord (L) is approximately
24.9 ohms.
Removal
Note: This component may be able to be
accessed without removing the microwave. If the
2 end screws on top of the outer cover are
accessible, the hidden vent can be removed
without removing the microwave from its
installation.
Remove the hidden vent (see
Microwave Removal
and Component Access). Press the tab with a
small screwdriver and lift the interior light cover up
and out.
Hidden Vent Motor
The hidden vent motor is located behind the
hidden vent on the right side.
Resistance through the hidden vent motor from
the CN03 pin 1 to the power cord (N) is
approximately 28.8 ohms.
Removal
Note: This component may be able to be
accessed without removing the microwave. If the
2 end screws on top of the outer cover are
accessible, the hidden vent can be removed
without removing the microwave from its
installation.
Remove the hidden vent (see
Microwave Removal
and Component Access). Remove 2 screws and
the motor.
Squeeze the 2 tabs of the light socket and remove
the light assembly.
Note: When installing a new halogen bulb, be
sure to handle the bulb with a clean, dry cloth.
Replace the halogen lamp with a 120VAC, 20W
GE halogen lamp bulb (WB36X10213).