Filter
Top Products
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
OVEN WILL NOT
COME ON
CONTROL PANEL
LIGHTED. YET OVEN
WILL NOT START
"PROBE" APPEARS
ON DISPLAY
'Error" APPEARS
ON DISPLAY
'HOT" APPEARS
ON DISPLAY
FLOOR OF THE
OVEN IS WARM.
EVEN WHEN THE
OVEN HAS NOT
POSSIBLE CAUSE
• A fuse in your home may be blown or the circuit breaker tripped. Replace fuse or
reset circuit breaker.
• Unplug your microwave, Convection oven. then plug it back in.
• Make sure 3-prong plug on oven is fully inserted into wall receptacle.
• Door not securely closed.
• START pad must be touched after entering cooking selection.
• Another selection entered already in oven and CLEAR/OFF pad not touched
to cancel it.
• Make sure you have entered cooking time or temperature after touching one of the
cooking pads.
• CLEAWOFF pad was touched accidentally. Reset cooking program and touch
START pad.
• Temperature probe not inserted properly or not being used during Combination
Roast or Temp Cook/Hold.
• Make sure you have entered a desired finished food temperature or oven temperature
after setting temperature cooking programs.
• Make sure you have entered a code number after touching Sensor COOK.
• Temperature probe is missing or not plugged in securely when using cooking
functions that measure food temperature.
• Temperature probe is inserted for a program that does not use the probe.
• During Cook, Reheat. Beverage or Popcorn program, the door was opened before
steam could be detected, or steam was not detected in maximum time.
• This is normal when the temperature inside the oven is greater than 200 degrees and
the door is opened.
• One of the sensor cooking pads was touched when the temperature inside the oven
was greater than 200 degrees. These features will not operate when the oven is hot.
• The cooktop lamp is located directly below the oven floor. When the lamp is on.
the heat it produces makes the oven floor get vv°arm. This is normal.
BEEN USED
All these things are normal with your microwave oven:
• Steam or vapor escaping from around the door.
• Light reflection around door or outer case.
• Dimming oven light and change in blower sound
may occur while operating at power levels other
than high.
• Dull thumping sound while oven is operating.
• Some TV-Radio interference might be noticed while
using your microwave oven. It's similar to the
interference caused by other small appliances and
does not indicate a problem with your oven.
If you need more help...call, toll free: GE Answer Center _*/ 800.626.2000 / consumer information service
34