Filter
Top Products
Installation Instructions
ISTEP 161 DISHWASHER WET TEST
[] Turn on power supply (or plug power cord into
outlet, if equipped).
[] Turn dial to Normal "Wash" position.
[] Close door.
[] Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, checkto
be sure that water and power are turned on.
[] Check for leaks under the dishwasher. If a leak is
found, turn power supply off, then tighten connec-
tions. Restore power after leak is corrected.
[] Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the dish-
washer if necessary. See Step 9.
[] The dishwasher will drain and turn off about 5 to
7 minutes after the first fill. Check drain lines.
If leaks are found, turn power off atthe breaker
and correct plumbing as necessary. Restore power
after corrections are made. See Step 12.
[] Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 13.Also check drain line for kinking.
[] Runthe dishwasher through another fill and drain
cycle. Check for leaks and correct if required.
[] Atthe end of drain, open door and turn dial to
OFFposition.
STEP 17 REPLACE TOEKICK
FigureZ
o io
oekick
Adjust_
or Down
Place 2-piece toekick againstthe legs of the
dishwasher.
Place the inner toekick piece (with slots) against
the toekick bracket. The slots should align with
toekick bracket screw holes. Allow the toekick to
touch the floor.
Place larger toekick over the inner piece and install
4 toekick screws.
Use additional 2 screws for installations over
33-1/2" high.
Use both toekick pieces for all installation heights.
I STEP 181 LITERATURE
Be sure to leave complete literature package and
installation instructions with consumer.
SPECIFICATIONSSUBJECTTOCHANGEWITHOUTNOTICE
Pub.No.31-30566
Dwg.No.206C1559P106
PrintedinChina 07-03JR