Filter
Top Products
Installation Instructions
I STEP 21ADJUST LEVELING LEGS
• Move the dishwasher close to the installation
location and lay it on its back.
/
Adjust to
Installation
Height
FigureH
• Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4"less than installation height.
I STEP 31REMOVE TOEKICK
• Remove the 4 toekick screws. Lift off the 2 piece
toekick.
FigureJ
6
I STEP 41 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
• Recommended power cord length is 54" min. and
64" max.
A
Remove
Junction Box
Cover
B CheckThat White, Black and
Green Dishwasher Wires Are Threaded
Thru Hole in Back
Ground fWhite
-_ Black
D Use ULListed
Wire Nuts
Figure K
C
• Connect incoming CordWires Thru
Strain Relief
power cord white (or ribbed) and Tighten
to dishwasher white, black
(or smooth) to black and ground to dishwasher green
wire. Use UL listed wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not
pinched under the cover.
I STEP 51 INSTALL 90 ° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
Fill
Hose
90°
Elbow
Water
Valve
Bracket
Thread
FigureL Seal Tape
• Do not over tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.