Filter
Top Products
Jock
To Set the Clock
The
clock
must be set for the
automatic oven timing functions to
work properly. The time
of day
cannot
be changed during a Timed
Bake
or
CLEAN cycle.
❑
1.
Press the
CLOCK pad.
CLOCK
T
2. Press the
A
INCREASE or
DECREASE pad
~
to set the time
of day.
3. Press the CLOCK pad to start.
Timer
To Set the Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer is
9
hours and
SS
minutes.
7
1.
Press the TIMER
TIMER
ON/OFF pad.
ONIOFF
2. Press the INCREASE or
DECREASE pad to set the
amount
of
time on timer.
The timer will start automatically
within a few seconds
of releasing
the INCREASE or DECREASE pad.
The timer,
as
you are setting it,
will display hours and minutes;
“HR
>
’ will be in the display.
During the countdown, when the
timer reaches the last minute, the
display
will
change to seconds
only and a single beep will sound.
J
Reset the
Timer
To Cancel the Timer
If “TIMER’
-
is flashing, press the INCREASE or Press the TIMER ON/OFF pad while the word
DECREASE pad until the desired time is reached. “TIMER” is flashing.
If
“TIMER” is not flashing, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of
Cycle
Tone
The end of
cycle
tone is a series of
3
beeps followed
by
I
beep every
6
seconds. If you would like to
remove the
signal
that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for
I
() seconds.
Power Outage
After a power outage, when power is restored, the
display will
flash
and time shown will no longer be
correct—for example, after
a
5-minute power
interruption the clock will be 5 minutes slow.
other functions that were in operation when the
power went out
will
have to be programmed
again.
7