Consumer SupportTroubleshooting Tips
Operating InstructionsSafety Instructions
Installation Instructions
Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker
If the refrigerator has an icemaker, it will have to be
connected to a cold water line.
A water supply kit (containing copper tubing,
shutoff valve, fittings and instructions) is available
at extra cost from your dealer or from Parts and
Accessories, 800.626.2002.
Refrigerator Location
Do not install the refrigerator where the
temperature will go below 60°F (16°C)
because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it
fully loaded.
Clearances
Allow the following clearances for ease of
installation, proper air circulation and
plumbing and electrical connections:
Sides . . . . . . . . . . . . . . . . . . . . . . . . . . .3/16″(4.8 mm)
Side (on hinge side
next to a wall) . . . . . . . . . . . . . . . . . . .2
1
⁄8″(54 mm)
Top . . . . . . . . . . . . . . . . . . . . . . . . . . . .1″(25 mm)
Back . . . . . . . . . . . . . . . . . . . . . . . . . . . .1″(25 mm)
Rollers
The rollers have 3 purposes:
Rollers adjust so the door closes easily when
opened about halfway. [Front of refrigerator
should be 1/4″(6 mm) higher than the rear
of refrigerator.]
Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
Rollers allow you to move the refrigerator away
from the wall for cleaning.
To adjust the rollers:
Remove the base grille.
Turn the roller adjusting
screws
clockwise to
raise
the refrigerator,
counterclockwise to
lower it.
Use a 3/8″
socket wrench or
adjustable wrench.
Replace the base grille.
Base Grille
Remove both end
caps, then remove
the base grille by
grasping it at the
bottom and pulling
it straight out.
To replace the base
grille, align prongs on
back of grille with slots
in cabinet and push
forward until the grille
snaps into place. Snap
the top of the end
caps on first, then
the bottom.
Roller Adjustment Screw
(3/8″hex with slot)
Roller
Stabilizing
Brake
11
Base
Grille
End Cap