Filter
Top Products
Consumer SupportTroubleshooting Tips
Operating InstructionsSafety Instructions
Installation Instructions
13
Remove the Refrigerator Door
Remove the top hinge cover (lift up on the
outside edge and pull off).
Tape the door shut with masking tape at
both upper corners.
With 5/16″hex socket driver, remove the
3 screws that hold the top hinge to the cabinet.
Lift the hinge straight up to free the hinge pin
from the socket in the top of the door. Carefully
peel off the adhesive backed spacer from the top
of the cabinet.
Remove the tape, tilt the door away from the
cabinet and lift it to free its bottom socket from
the hinge pin on the center hinge bracket.
Set the door on a non-scratching surface.
Before Removing the Doors
Unplug the refrigerator from its electrical
outlet.
Empty all door shelves, including the dairy
compartment.
CAUTION: Do not let either door drop to the floor. To do so
could damage the door stop.
To Reverse the Refrigerator Door—
Transfer Center Hinge Bracket to the Left
Open the freezer drawer and remove the hinge
bracket from the center right side of the cabinet
by removing the three Phillips head screws.
Remove the three outermost 5/16″hex head
screws from the center left side of the cabinet
and insert them into the holes just vacated by
the Phillips head screws on the center right side.
Remove the center hinge pin from the hinge
bracket using a 5/16″hex socket driver. Invert
the hinge bracket with shim and reinstall hinge
pin in hinge bracket. Secure this assembly with
the three Phillips head screws removed from the
right side. Tighten all screws.
NOTE:
If the washer is not on the hinge pin,
check to see if it is stuck to the bottom of
the door.
Center Right
Center Left
Center Hinge Pin
Plastic Washer
Center Hinge Pin
Plastic Washer