Filter
Top Products
13
NOTE: The middle rail separating the two
openings may need to be larger than the 2”
(5.1 cm) minimum shown. Always refer to the
individual installation instructions packed with
each product for specific requirements.
Combined Advantium or Microwave
Oven and Wall Oven Installation:
When installed in combination with a
single wall oven, use separate electrical
junction boxes.
• Refer to the Advantium or microwave
oven installation instructions for electrical
requirements of that product.
• These connections must be made
by a qualified electrician. All electrical
connections must meet National Electrical
Code or prevailing local codes.
NOTE: Additional clearances may be
required. Check to be sure the oven
supports above the Warming Drawer
do not obstruct the required interior depth
and height. The middle rail separating the
openings may need to be larger than the
2” (5.1 cm) minimum shown. Always refer to
the individual installation instructions packed
with each product for specific requirements.
Warming Drawer Combined with
Advantium or Microwave Oven and
Single Oven:
Install a separate 120V, 60Hz, properly
grounded receptacle. See installation
instructions packed with each product
for specific requirements.
Note: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
Cabinetry
Single 30″ (76.2 cm) Oven
Below an Advantium or
Microwave Oven
Single 30″ (76.2 cm) Oven
Between an Advantium or
Microwave Oven and a
Warming Drawer
Cutout for 30″ (76.2 cm) Single Ovens only –
Below an Advantium or Microwave Oven
or Between an Advantium or Microwave
Oven and a Warming Drawer
For JTP30, JTP70, PT916, PT920, ZET938 models only.
A
2” (5.1 cm) Min.
2” (5.1 cm) Min.
Per Advantium or
Microwave Oven
Requirement
Per Warming
Drawer
Requirement
2” (5.1 cm) Min.
Per Advantium or
Microwave Oven
Requirement