GE JSP57 Range User Manual


 
32
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Care and cleaning of the range.
Oven Light Replacement (on some models)
CAUTION: Before replacing your oven
light bulb, disconnect the electrical power to the
range at the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
To remove the cover:
Twist lens counterclockwise about a
quarter turn to remove.
Do not remove any screws to remove
the cover.
Replace bulb with a 40-watt
appliance bulb or two-prong
halogen bulb as appropriate.
To replace the cover:
Line up tabs of lens in front of tabs
on housing and rotate clockwise to
engage.
Connect electrical power to the
range.
Broiler Pan and Grid
Do not clean the broiler pan or grid in a self-
cleaning oven.
After broiling, remove the broiler pan
from the oven. Remove the grid from the
pan. Carefully pour out the grease from
the pan into a proper container.
Wash and rinse the broiler pan and grid in hot
water with a soap-filled or plastic scouring pad.
If food has burned on, sprinkle the grid
with detergent while hot and cover with
wet paper towels or a dishcloth. Soaking
the pan will remove burned-on foods.
Both the broiler pan and grid may be cleaned with
a commercial oven cleaner.
Both the broiler pan and grid can also be
cleaned in a dishwasher.
Do not store a soiled broiler pan
and grid anywhere in the range.
Oven Heating Elements
Do not clean the broil element. Any soil
will burn off when the element is heated.
Clean the oven floor with warm, soapy
water.
On some models, the bake element is not
exposed and is under the oven floor. If spillovers,
residue or ash accumulate on the oven floor, wipe
up before self-cleaning.
Storage Drawer Removal
To remove the drawer:
Pull the drawer out until it stops.
Lift the front of the drawer until the
stops clear the guides.
Remove the drawer.
To replace the drawer:
Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and
push back until the stops clear the
guides.
Lower the front of the drawer and
push back until it closes.
Stop guide
Rail