Filter
Top Products
Using the surface units.
NOTE: Throughout this manual, features and appearance may vary from your model.
How to Set
Push the knob in and turn in either
direction to the setting you want.
At both OFF and HI the control clicks
into position. You may hear slight
clicking sounds during cooking,
indicating the control is keeping the
power level you set.
A HOT SURFACE indicator light, on the
cooktop, will glow when any radiant
element is turned on. It will remain
on until the surface is cooled to
approximately 150°F.
Hot surface indicator light will:
■ come on when the unit is hot to the touch.
■ stay on even after the unit is turned off.
■ glow until the unit is cooled to approximately
150°F.
The WARM setting on the right REAR
surface unit keeps already heated food
warm until ready to serve. Do not use to
heat cold food.
Be sure you turn the control knob to
OFF when you finish cooking.
Using the Bridge Surface Unit
To use the bridge surface unit, turn the
left front control knob to the BRIDGE
settings.
For full bridge surface unit operation,
also turn on the left rear surface unit.
To use only the front surface unit, turn
the control knob to the FRONT settings.
B
A
K
E
P
R
O
B
E
C
o
n
v
e
c
t
i
o
n
C
L
O
C
K
B
R
O
IL
C
O
N
V
B
A
K
E
R
O
A
S
T
S
E
L
F
C
LE
A
N
C
O
O
K
I
N
G
T
I
M
E
C
L
E
A
R
O
F
F
D
E
L
A
Y
S
T
A
R
T
C
O
N
T
R
O
L
L
O
C
K
O
U
T
S
U
R
F
A
C
E
W
A
R
M
E
R
S
E
T
O
F
F
K
I
T
C
H
E
N
T
I
M
E
R
O
V
E
N
L
I
G
H
T
O
N
O
F
F
O
V
E
N
C
O
N
T
R
O
L
S
T
I
M
E
C
O
N
T
R
O
L
S
S
T
A
R
T
6
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Using the Warming Zone (on some models)
The WARMING ZONE, located in the
center of the glass cooktop surface,
will keep hot, cooked food at serving
temperature. Always start with hot food.
Do not use to heat cold food. Placing
uncooked or cold food on the WARMING
ZONE could result in food-borne illness.
Touch the WARMING ZONE
SET•OFF pad.
Touch the number pads 1, 2 or 3
to select low (1), medium (2) or
high (3) warming setting.
Touch the START pad.
To turn the WARMING ZONE off, touch the
WARMING ZONE SET•OFF pad until
WARMER disappears from the display.
For best results, all foods on the
WARMING ZONE should be covered with a
lid or aluminum foil. When warming
pastries or breads, the cover should be
vented to allow moisture to escape.
Always use pot holders or oven mitts
when removing food from the WARMING
ZONE, since cookware and plates will be
hot.
CAUTION: Do not warm food on the
WARMING ZONE for more than two hours.
NOTE: The warming zone will not glow red like
the cooking elements.
HOT will be displayed when the glass
surface is hot and will remain on until
the surface is cool enough to touch.
NOTE: Lower settings may not heat the glass
surface enough to cause the HOT indicator light
to come on.
A warming zone ON light will glow when
the unit is on.
■ Do not use plastic wrap to cover food. Plastic
may melt onto the surface and be very difficult
to clean.
■ Use only cookware recommended for
top-of-range cooking.
WARMING ZONE GUIDE
SETTING FOOD
1 (Low) Bread/Pastries
2 (Medium) Chocolate/Butter
2 (Medium) Sauces, Stews,
Cream Soups
2 (Medium) Vegetables
3 (High) Soups (liquid)
3 (High) Tea or Coffee
The Warming Zone Guide is for
reference only and the SETTING
that you need will depend on the
amount and type of food, the
starting temperature of the food
and the length of the holding time.