Open as PDF
All of the full extension drawers pull out
so bottles can be conveniently added or
Any of the full extension drawers can be
removed to store larger bottles.
1. Pull the full extension drawer out to the
2. Push the tab on right drawer guide down
while pulling the tab on left guide up,
and pull the drawer out.
1. Push the drawer slide arm back into
2. Pull the small slide sub assembly
3. Insert the sides of the drawer back into
4. Push until the tabs lock into place.
Tab (push tab down on
right drawer guide, pull
tab up on left drawer
Controls and Features
The temperature range of the wine chiller
is from the low forties to the mid sixties.
Do not install the wine chiller where the
temperature will go below 55°F (13°C) or
above 90°F (32°C).
The RED WINE setting will provide a
storage temperature of approximately
55ºF (13ºC), which is optimum for the
storage for red wine.
The WHITE WINE setting will provide a
storage temperature of approximately 45ºF
(7ºC), which is optimum for white wine.
As with any refrigeration product, there is
a slight temperature variance at different
locations within the cabinet.
Temperatures at the bottom of the cabinet
will be cooler than temperatures at the top
of the cabinet.
Position your wine inventory accordingly
(i.e. white wines in the cooler zones and
red in the warmer zones).
To set the control, turn it to the RED WINE
setting. Once the bottles are loaded, allow
at least 24 hours before making any
adjustments to the initial setting.
The interior light makes it easy to view
your wine labels and enhances the display
of your collection.
When the switch is in the OFF position,
the light comes on only when the door is
opened. When the switch is in the ON
position, the light remains on continuously
for your maximum viewing pleasure.
For best viewing do not store a bottle on
the top shelf directly under the light.
Remember to turn off the light when it
is no longer needed.
NOTE: Make sure the tabs on the full
extension drawer guides are fully engaged
before loading any bottles. Pull the drawers
out all the way to the STOP position and
push back in several times to make sure
locking tabs are properly engaged.
To replace, push drawer slide
arm back into unit
Pull small slide sub assembly