Filter
Top Products
26
3/4″ custom door panel must be routed to
accommodate these door handle extrusions. Rout
the panel as illustrated, 1/4″ deep, and 1-13/16″ wide
on the handle side.
Refer to installation instructions for ZKTR36LH or
ZKTR36RH trim kit for 3/4″ custom panels:
• Follow Step 1 to remove the standard
aluminum trim.
• Follow Steps 2 and 3 to attach new 3/4″ trim pieces
and to install panel support brackets.
Right hand door swing models are illustrated in these
instructions. Follow these instructions for left hand
models.
Tools and materials required:
• #2 Phillips screwdriver
• Drill and appropriate bits
• Custom door panel
• Custom handle
• Safety glasses
NOTE: This kit must be used in combination with
ZKTR36LH or ZKTR36RH trim kit for 3/4
″ panel trim.
Part List:
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
This kit provides the necessary framework to
install a custom handle, of your choice, onto a 3/4″
thick decorator door panel. (Handles not included.)
The handle extrusion allows the custom handle to be
secured to the door structure, rather than the door
panel.
• Select handle extrusion for your model, discard
other extrusion.
Kit Contents
Before
you begin
IMPORTANT: Optimal final appearance depends on
careful routing depth. Do not exceed 1/4
″ routing depth.
1-13/16"
Back Side
Handle Side
Custom Panel
1/4" Max.
ZKHTR1 Trim Kit (For 3/4″ Panels)
Support for Custom Handles