Filter
Top Products
31
Step 3
Install
standoffs
onto handles
• Place a handle standoff onto each attachment post
along the handle. Position the set screw hole on the
standoff to point to the floor.
• Install set screws into the bottom of each standoff,
using the Allen wrench provided. The standoff
should be tight against the handle.
Step 4
Install
handles
and panels
FOR CUSTOM
WOOD
PANELS
See Step 4A
for stainless
steel panels
• Slide panel into the door trim. Leave about 4″ of the
panel exposed to allow room to install the handle
extrusion.
• Place extrusion onto the back side of the panel,
install mounting screws through the extrusion and
just through the panel.
• Drive screw part way through the top standoff,
then part way through the bottom standoff. Install
remaining standoffs part way.
• Drive all screws until the handle is tight against the
panel.
• Remove tape.
• Slide the assembled panel into the door trim until
the extrusion fits firmly against the steel door.
Reinstall original screws into the extrusion.
Screw
Allen Wrench
Screw
Handle
Decorator
Door Panel
ZKHRSS1 Trim Kit (For 1/4″ Panels)
Tubular Stainless Steel Handles