Filter
Top Products
6
Installation Preparation
REMOVE THE PACKAGING
• Remove the duct cover, parts box and other
packaging.
• Lift the hood out of the box.
• Remove and properly discard the plastic wrapping.
• Remove junction box cover.
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Tape measure
Knife
Spirit level
Wire cutter/stripper
Wire nuts
Electric drill with 1/8" and 3/8" bits
Phillips and flat blade screwdrivers
Hammer
Pliers
Safety glasses
Duct tape
Tape to mount template
Gloves to protect against sharp edges
120V 60Hz. 15 or 20 Amp, 2 wire with
ground Properly grounded branch circuit
Strain relief for junction cover
6" round metal duct, length to suit
installation
Saw or jig saw
Conduit for house wiring
and conduit connector
Measuring Tape
Electric drill
with 1/8” and
3/8” Bits
Phillips
head
screwdriver
Safety glasses
Gloves
Spirit level
Knife
Wire
cutter/stripper
Flat blade
screwdriver
Hammer
Pliers
Duct Tape
Masking tape
Wire nuts
Strain relief for
junction cover
2-piece duct
cover
Saw or jig saw
Conduit