Filter
Top Products
Surface Cooking
Stainless Steel Range
10
Push the control in and turn it counterclockwise
to the LITE position.
Control
knobs
The control knobs are in front of the burner
they control. The oven controls are placed slightly
lower than the surface burner control knobs.
The surface burners have an infinite number of
heat settings as there are no fixed positions
between HI and LO.
To turn ON a surface burner, push the control in,
then turn it counterclockwise to the LITE
position.
Check to be sure the burner you turned on is the
one you want to use.
You will hear the ignitor click. When the gas is
ignited all around the burner and into the central
simmer burner below the simmer cap, turn the
knob back to the desired setting.
When using the simmer burner, always ensure
that it lights from the main burner.
Outer cap/port ring
Simmer burner
Simmer cap
Burners
Your new professional gas range is equipped with
burners typical of those used in restaurants.
These burners are designed in two pieces for
easy cleaning and control.
The center, smaller cap covers and protects the
simmer burner from boilovers that could put the
flame out. This cap also spreads the simmer
burner heat out to avoid too much heat being
concentrated on the center of the pan.
The simmer burner is always on when the burner
is in use. The burner should never be operated if
the simmer cap is not in place.
The outer cap /port ring constitute the main
burner and are in operation between the HI
and LO settings.
The burners have electronic spark ignition to
eliminate continuously burning pilots. When the
outer cap/port ring is on and the flame is blown
out, it will relight. The burners are rated at 15,000
BTU around the outer cap/port ring. When
turned to the simmer setting, only the center
of the burner is lit, and it is rated at 500 BTU.