Filter
Top Products
Operating Instructions
Safety InstructionsCare and CleaningInstallation InstructionsTroubleshooting Tips
20
International Installation Instructions.
(220–240, 50/60Hz, 2-wire)
Final Check
Be sure all range controls are in the OFF position
before leaving the range.
Anti-Tip Device Installation
Read these instructions completely and carefully.
Leveling the Range
A. Remove the storage
drawer, broiler drawer or
kick panel.
B. Use a 3/16″ open-end or
socket wrench to back out
both rear leveling legs
approximately two turns.
C. Use a 1
3
⁄8″ open-end or
adjustable wrench to back out the front leveling
legs two turns.
D. Install the oven shelves in the oven and position
the range where it will be installed.
E. Check for levelness by placing a spirit level or a
cup, partially filled with water, on one of the
oven shelves. If using a spirit level, take two
readings—with the level placed diagonally first
in one direction and then the other.
F. Adjust the leveling legs until the range is level.
WARNING
■ Range MUST be secured by the
Anti-Tip device
supplied.
■ Unless properly installed, the range could be
tipped by stepping or sitting on the door. Injury
might result from spilled hot liquids or from the
range itself.
■ After installing the
Anti-Tip device
verify that it is
in place by carefully attempting to tilt the range
forward.
■ This range has been designed to meet all
recognized industry tip standards for all normal
conditions.
■ The use of this device does not preclude tipping
of the range when not properly installed.
■ If the
Anti-Tip device
supplied with the range
does not fit this application, use the universal
Anti-Tip device
WB02X7909.
An
Anti-Tip bracket
is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the
Safety
Instructions
and the instructions that fit your
situation before beginning installation.
Typical installation of anti-tip bracket attachment to wall.
Bracket
Screw must
enter wood
or metal
Wall plate