GE Monogram Wine Vault Beverage Dispenser User Manual


 
Cooling Unit does not operate.
Possible Cause Recommended Solution
Power switch set to OFF. Set power switch on cooling unit to ON.
Power cord unplugged. Make sure that the Cooling Unit power cord is plugged into
the grounded outlet.
Blown fuse or tripped Replace the fuse or reset the circuit breaker.
circuit breaker.
IMPORTANT: The unit must be plugged into a
30-amp
, 110-volt circuit.
Wine Vault is too cold.
Possible Cause Recommended Solution
Thermostat not Adjust the thermostat on the cooling unit. Refer to the
set correctly. Cooling System section for details.
Liquid probe in incorrect Make sure that the liquid probe is set up and positioned
location or not connected as described in the Cooling System section.
Exterior room temperature Increase temperature of the exterior room to between
is below 45
°F. 45°F and 85°F.
Wine Vault is too warm.
Possible Cause Recommended Solution
Temperature control not set Adjust the thermostat and allow 48–120 hours for the unit
to cold enough. reach the set temperature.
Warm exterior room. Adjust the temperature in the exterior room to
between 45°F and 85°F.
Foreign object holding the Check doorway for debris and other obstructions.
door open.
Frequent door openings. Minimize the length of time the door is left opened.
Liquid probe in incorrect Make sure that the liquid probe is set up and positioned
location or not connected. as described in the Cooling System section.
Object impeding airflow to Move any object that may be blocking the airflow in
the cooling unit. front of the cooling unit on the inside or outside of the
wine vault.
Warm wine bottles recently Allow 48–120 hours for the cooling unit to stabilize
added to the wine vault. the temperature.
30
TROUBLESHOOTING
The dr
ops of wine that slide down the sides of the glass when it is swirled are the legs.
Cooling System