Filter
Top Products
13
Care and Cleaning
Dishwasher
Exterior
To clean the control panel, use a lightly
dampened cloth, then dry thoroughly. To clean
the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh
cleaners on any part of the dishwasher.
Spray Arms
and Filters
The dishwasher will flush away all normal food
soils. However, objects (fruit pits, bones, etc.)
may collect in openings and should be
removed occasionally to avoid clogging the
drain system.
CAUTION: Personal injury
hazard. Before cleaning the interior, wait at
least 20 minutes after a cycle for the heating
element to cool down. Failure to do so could
result in burn injuries.
Cleaning the Spray Arms
Because hard water chemicals will clog the
spray arm jets and bearings, it is necessary to
clean the spray arms regularly. To remove the
spray arm, twist the retaining nut 90 degrees
and pull the spray arm off the shaft.
Wash the arms in soapy, warm water and use a
soft brush to clean the jets. Replace them after
rinsing thoroughly.
Cleaning the Filters
For best performance and results, the filter
assembly must be cleaned regularly. The filter
efficiently removes food particles from the wash
water, allowing water to be recirculated during
the cycle. For this reason, it is a good idea to
remove the large food particles trapped in the
filter frequently by rinsing the main filter and
cup under running water. To remove the filter
assembly, pull up on the cup handle. The
entire filter assembly should be cleaned at least
once a month. To clean the main filter and fine
filter, use a cleaning brush. Then, reassemble
the filter parts as shown in the illustration and
reinsert the entire assembly in the dishwasher,
positioning it in place and pressing downward.
The dishwasher must never be used without the
filters. Improper replacement of the filter may
reduce the performance level of the appliance
and may damage dishes and utensils.
Retaining
nut
Washer
Retaining nut
Upper rack
Main filter
Fine filter
Cup