GE Monogram ZBD6880K Dishwasher User Manual


 
LEVEL DISHWASHER
IMPORTANT Dishwasher must be level
for proper dish rack operation and wash performance.
Place level on door
and rack track inside
the tub as shown to
check that the
dishwasher is level.
Level the
dishwasher by
adjusting the
four leveling legs
individually.
If adjustment to the
right rear leveling
leg is required, gain
access by loosening
junction box bracket screw (through the access hole)
and rotate bracket clockwise.
TIP: Pull lower rack out, about halfway. Check to
be sure the rack does not roll forward or back into
dishwasher. If the rack rolls in either direction, the
dishwasher must be leveled again.
If the door hits the tub, the dishwasher is not installed
correctly. Adjust leveling legs to align door to tub.
STEP 11
11
Check
Level
Side
To Side
Check
Level
Front
to Back
Turn Legs
to Adjust
Access Hole
Installation Instructions
Figure W
Figure X
SECURE DISHWASHER TO CABINET
STEP 12
The dishwasher must be secured to the countertop or
the cabinet sides. When countertops are made of wood,
use Method 1. When countertops are granite or other
materials that will not accept screws, use Method 2 to
secure dishwasher at the sides.
IMPORTANT After leveling, verify that
the dishwasher is still in the correct position shown in
Step 10.
IMPORTANT Drive screws straight and
flush. Protruding screw heads will scratch the top or
sides of the control panel and can interfere with door
closing.
Method 1—Secure dishwasher to wood
countertop
Fasten the dishwasher to the underside of the
countertop with 2 Phillips screws provided.
Method 2—Secure dishwasher with side
mounting brackets
Remove plug buttons (one on each side).
Install screw through the hole in the side of the
dishwasher and into the adjacent cabinet.
Reinstall plug buttons.
Countertop
Mounting
Brackets
Tub
Frame
Side Mounting
Brackets
Figure Y
Figure AA
Brackets
Wood Countertop
Screws
Plug Buttons
Side Mounting Brackets
Stone Countertop
Figure Z