GE Monogram ZBD6880K Dishwasher User Manual


 
REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT Do not kick off wood base!
Damage will occur.
Move the dishwasher close to the installation location
and lay it on its back.
Remove the four leveling legs on the underside of
the wood base with an adjustable wrench or 15/16"
socket.
Discard base.
Screw leveling legs back into the dishwasher frame,
approximately 1/4" from frame as shown.
STEP 2
REMOVE TOEKICK
Remove the two toekick screws.
STEP 3
8
T
oekick
Remove 2
Toekick Screws
Installation Instructions
Figure H
Approx.
1/4"
Figure J
INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or
has a factory installed power cord.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
Maximum power cord length is 4 feet beyond the
back of the dishwasher.
Connect incoming power cord white (or ribbed) to
dishwasher white, black (or smooth) to black and
ground to dishwasher green wire. Use UL listed wire
nuts of appropriate size.
Replace junction box cover. Be sure wires are not
pinched under the cover.
STEP 4
White
Ground
Black
Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
Remove
Junction Box
Cover
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Use UL Listed
Wire Nuts
A
C
B
D
Figure K
INSTALL 90° ELBOW
Wrap 90° elbow with thread seal tape.
Install a 90° elbow onto the water valve.
Do not overtighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
Position the end of the elbow to face the rear of the
dishwasher.
STEP 5
Front of Dishwasher
90°
Elbow
Thread
Seal Tape
Fill
Hose
Water Valve
Bracket
Figure L