GE Monogram ZBD6880K Dishwasher User Manual


 
REPLACE TOEKICK
Place toekick against the legs of the dishwasher.
Align the toekick with the bottom edge and make sure
it is against the floor.
Insert and tighten the two toekick attachment screws.
The toekick should stay in contact with the floor.
TIP: Make sure toekick is against floor to minimize
noise.
STEP 18
14
Toekick
Attachment Screws
Installation Instructions
LITERATURE
Be sure to leave complete literature package and
installation instructions with the consumer.
STEP 19
Figure HH
DISHWASHER WET TEST
Turn on power supply (or plug power cord into
outlet, if equipped).
Start the unit to check for leaks.
Push RINSE ONLY pad.
Push START/RESET pad one time.
Close door.
Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to
be sure that water and power are turned on.
Check for leaks under the dishwasher. If a leak
is found, turn power supply off, then tighten
connections. Restore power after leak is corrected.
Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the
dishwasher if necessary. See Step 12.
The dishwasher will drain and turn off about
5 minutes after it was started. Check drain lines.
If leaks are found, turn power off at the breaker
and correct plumbing as necessary. Restore power
after corrections are made. See Step 14.
Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 14. Also check drain line for kinking.
Run the dishwasher through another Rinse Only
cycle. Check for leaks and correct if required.
STEP 17