Filter
Top Products
15
Push the control knob down and turn it
counterclockwise to the LITE position.
After the burner ignites, turn the knob in either
direction to adjust the flame size.
To turn a burner off, turn the knob clockwise,
as far as it will go, to the OFF position.
• All of the burners can be used for both
general cooking and simmering.
• Do not operate a burner for an extended
period of time without cookware on the
grate. The finish on the grate may chip
without cookware to absorb the heat.
• For your convenience, the indicator lamp
in the bezel for each knob verifies the burner
is “ON”.
• Be sure you turn the control knob to “OFF”
when you finish cooking.
Electronic
ignition &
automatic
reignition
Your surface burners are equipped with
electronic ignition which eliminates the need
for a standing pilot light.
All igniters will spark and make clicking sounds
when only one burner is being turned on.
Do not touch any of the burners when igniters
are clicking.
The burners on this range will automatically
relight if the flame goes out. All burners will
spark while any one burner is relighting.
Burners may spark if wind or a draft lifts the
flame away from the flame sensor.
In case of a power outage, you can light the
surface burners on your cooktop with a match.
Hold a lighted match to the burner, then turn
the knob to the HIGH position. Use extreme
caution when lighting burners this way.
How to
select
flame size
Watch the flame, not the knob, as you increase
or reduce heat.
The flame size on a gas burner should match
the cookware you are using.
FOR SAFE HANDLING OF COOKWARE,
NEVER LET THE FLAME EXTEND UP THE
SIDES OF THE COOKWARE. Any flame larger
than the bottom of the cookware is wasted and
only serves to heat the handle.
To light
a burner
NOTE: Use 10″ or larger diameter cookware
when using heat settings between HI and
X-HI.
LITE
ER
Surface Cooking
Stainless Steel Range