Filter
Top Products
HALOGEN/RADIANT SURFACE UNIT CONTROLS
Halogen Surface Unit
The controls selected for the halogenhadiant
component will give you a full range of heat settings
for cooking.
The control knobs must be pushed down to turn
from the off (0) position. When the control knobs
are in any position other than off(0), they may be
turned without pushing down.
You may notice that the knob that operates the
halogen surface unit is slightly harder to turn than
the knob for the radiant surface unit. This is due
to the difference in design between the two controls.
NOTE:
. The lowest three settings will produce no visible
evidence of the surface unit being on although up
to 11% of the total wattage is being generated. On
the lowest settings, the percentage of power may
not cause the hot surface lights to light. An indicator
light near the control knobs will glow when either
surface unit is on.
● The burner “on” light will glow for all positions
except the off position.
The eleven position halogen control produces the
following variation in cooking power.
Switch
Settings
L HI
Position
10
I
‘: I OFF
1
Brightness
of Lamp
Full
High
High
Medium
Medium
Low
Low
Invisible
Invisible
Invisible
Invisible
Typical Heater
Power
(Yo)
100
76
56
41
30
23
16
11
8
5
0
If the halogen/radiant component is connected to 208
volts, you will notice some increase in cooking times.
Radiant Surface Unit
The control for the radiant surface unit is an infinite
switch that can be set anywhere between LO and HI
for an unlimited number of heat settings.Wxth the
infinite switch the coil cycles on and off to maintain
your selected control setting.
The control knobs must be pushed down to turn
from the off (0) position. When the control knobs
are in any position other than off(0), they may be
turned without pushing down.
Be sureyou turnthe conrol knob off(0) when
you finish cooking. You will feel a “click” at the
off position.
11