Filter
Top Products
Page 7
Operating Instructions
TO AVOID SERIOUS PERSONAL INJURY:
• DO NOT operate the mixer before reading the instruction manual fi rst.
• ALWAYS disconnect or unplug electrical power before cleaning, servicing, or adjusting any parts or
attachments.
• ALWAYS keep hands, hair, and clothing away from moving parts.
ATTACHING THE BOWL TO THE MIXER
NOTE: Install the bowl BEFORE attaching the agitators.
1. Lower the bowl by pushing the bowl lift lever backwards and down to its resting position.
2. Lift the bowl by the bowl handle and
a. slowly position the locking pin (located on the rear of the bowl) into the hole in the
middle rear of the cradle (see fi g 7-1).
b. lower the bowl onto the pins located on either side of the bowl cradle.
3. Once the bowl is positioned on the cradle, secure the bowl by pulling both bowl clamps
forward until the bowl is locked tight (see fi g 7-2).
ATTACHING THE AGITATOR TO THE MIXER (i.e., Beater, Hook, Whip)
NOTE: It is easier to install the agitator prior to adding the ingredients into the bowl.
1. The bowl should be in the lowered position and the bowl guard should be removed
(see fi g 7-3).
2. Slide the agitator slowly upwards onto the planetary shaft fi tting the shaft pin through the
slot in the agitator (see fi g 7-4).
3. Rotate the agitator clockwise to secure it onto the planetary shaft (see fi g 7-5).
MIXING INGREDIENTS
Follow the capacity chart located on page 12 in this owners manual.
Overloading or not following this chart will damage the mixer and void the
warranty.
IMPORTANT: Make sure the speed control lever is on the
fi rst (1) speed.
1. Add the appropriate mixing ingredients into the bowl.
Fig. 7-1
Fig. 7-2
Fig. 7-3
Fig. 7-4
Fig. 7-5