Filter
Top Products
5309160
Introduction
Each hose assembly must be controlled by a Graco
zone controller. The amount of hose used depends on
the zone controllers available for control.
The hose has two electrical connectors with cables,
each extending from the end of the hose.
The large rectangular connector is the machine end
and has 8 foot (2.42 m) of cable (see Fig. 1). The
small square connector is the gun end and has 2 foot
(0.6 m) of cable (see Fig. 2).
Fig. 1
PH00051
Fig. 2
Connect the machine end connector to the Graco
temperature controller by pushing the connector on the
mating receptacle of the temperature controller or
accessory device and securing the latch.
Connect the gun end connector to any temperature
controller accessory device. These include Graco
manual and automatic hot melt dispense valves,
pressure compensators, manifolds, headers, and
pressure regulators.