Filter
Top Products
9309160
Troubleshooting
Make sure there is electrical continuity (<10Ω) be-
tween the following pins of the large machine end
connector and the small gun end connector
Lack of electrical continuity between any of these pins
is a failure of the hose. Replace the hose assembly.
Continuity Between Connectors
Machine End Gun End
B1 1
B2 2
B3 5
B4 3
B5 4
C1 6
C2 7
GND GND
Fig. 3
Technical Data
Maximum fluid working pressure See table on page 2. . . . . . . . . . . . . . . . . . . .
Maximum working temperature See table on page 2. . . . . . . . . . . . . . . . . . . . .
Hose fluid fittings See table on page 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Power required 230 VAC, 50/60 Hz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Wetted parts PTFE core, SST couplings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Power consumption 50 3 watts/linear foot of hose. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
(164 10 watts/linear meter of hose)
Minimum Bend Radius Hose with No. 6 – No. 16 core = 8 in. (20 cm). . . . . . . . . . . . . . . . . . . . . . . . . . . .
Hose with No. 20 core = 12 in. (30 cm)