Filter
Top Products
PNEG-970 S2 Hopper w/ Collector Ring20
Assembly
2. WIRE THE COLLECTOR RING (cont.)
F. Wire the multi-conductor cord to the collector ring using the fork terminals provided in the
following manner.
1. Thermal Protection Leads
a. Wire the "P1" lead from the control panel to ring "1".
b. Wire the "P2" lead from the control panel to ring "2".
2. Drive Motor Leads
a. Wire the three (3) power leads to rings "3", "4", and "5".
b. Wire the ground lead to ring "9".
3. Auger Motor Leads
a. Wire the three (3) power leads to rings "6", "7", and "8".
b. Wire the ground lead to ring "9".
G. Replace the protective housing onto the collector ring.