Filter
Top Products
PNEG-970 S2 Hopper w/ Collector Ring 27
Start-Up
A. Make sure ALL shields are in place.
ALWAYS keep ALL guards and shields in place, until all the power is
disconnected and locked out.
B. Inspect the collector ring for any problems or potential problems.
C. Be aware of any emergency shutdown procedures. Two (2) people must always be in a
position where the operation of the equipment can be monitored.
D. Before starting the auger for the first time, make sure that all parts are assembled correctly
according to the instructions in this manual.
Danger! Failure to perform any or all of these pre-start checks may cause
damage to the equipment and/or cause SERIOUS INJURY or DEATH to those
in the work area.
Failure to perform any or all of these pre-start checks may also be a misuse
of the equipment. Any misuse of the equipment may void the warranty.
Warning! To ensure that the drive is not unexpectedly started, turn off and
lock out or tag out the power source before proceeding. Failure to observe
these precautions could result in bodily injury.
Make certain ONLY trained operators are in the work area before operating or
moving the machine. Two (2) people must always be in a position where the
operation of the equipment can be monitored.
1. Preform Pre-Start Checks