Haier AFD630IX Freezer User Manual


 
Icemaker Installation Instructions
Before using the icemaker
Cut the water pipe to desired length while ensuring it is free from excessive bends. Generally
the total length should not be more than 5m. A longer pipe may reduce water pressure and, as a
result, reduce the water output flow-rate and ice-making capacity;
The water pipe should be away from any heat sources as it is not heat-resistant;
The water pipe should be installed and tested by an Authorized Service gent;
The icemaker should be connected to a water source of a pressure between 1.5PSI and 7PSI;
Cleaning the ice cube tray
Deactivate the ice machine function on the
display panel.Take out the icemaker assembly.
Turn the icemaker assembly over ice cube tray will
be visible underneath.
Pull the elliptical fastener of the icemaker in
direction .
Take out the ice cube tray in direction .
After cleaning, re-install using reverse
of direction above. Push the ice machine firmly into place, Close the
freezer door, and activate the ice machine
function on the display panel.
Precautions
Never install the icemaker's water tube in an area with the ambient temperature below 0 to
avoid icing of water supply.
The icemaker will start ice cube making when the internal temperature reaches or is
below -12 . (If the icemaker is used for the first time or after an extended period of vacation,
the first loads of cubed ice should be discarded as there maybe impurities in the water tube).
After the appliance is installed, the water tube should be placed to prevent it from being
crushed.
Installation of the icemaker can only be carried out by an Authorized Service Agent.
This icemaker can only be supplied with drinking water.
Operating principle of the icemaker
Eight(8) ice cubes are made in every cycle. The ice making capacity depends on
ambient temperature, door-opening frequency, water pressure, freezer temperature and other
conditions. To ensure that the storage box is fully filled with cubed ice, empty the cubed
ice into the drawer frequently.
It is normal that some of the cubes stick to each other.
(This can be improved by decreasing water supply duration).
Note
For a newly installed refrigerator, please let the appliance operate for 24 hours
before making ice.
If this is your first icemaker
Some “cracking” sounds may be heard in the process of ice making, it's normal.
Cubed ice stored for an extended period may become opaque or emit an odor. Please empty
the cubed ice storage box regularly and clean it with warm water. Before putting the box back,
make sure to cool it down and to dry it. Otherwise cubed ices may stick to the box.
If you do not want to use the cubed ice storage box for an extended period
Turn the ice maker off by pressing J and then A2 on the panel. Take out all the cubed ice from
the storage box and wash the box with warm water. Wipe the box with a dry towel before
replacing it into the appliance. Turn off the valve between the water source and the appliance.
In order to use all of the available freezer storage compartment, the icemaker
assembly can be taken out permanently.
If you do not use cubed ice frequently
20
A
A