Filter
Top Products
8
How to fill rinse aid
EN
Rinse aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door.
When the low rinse aid indicator “
H” lights, you must load rinse aid.
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your appli-
ance, you must proceed as indicated below when loading the rinse
aid.
To open the dispenser, turn the “
2” cap in an anti-clockwise direction
and then pour in the rinse aid, making sure not to overfill. The amount
of rinse aid used for each cycle can be regulated by turning the “
3”
dose adjustor, located beneath the “
2” cap, with a screwdriver. There
are 6 different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying. If drops of water remain on the
dishes or spotting occurs, the dosage adjustor should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjustor to a lower setting.
How to fill the detergent dispenser
Detergent
Detergent specifically intended for use with dishwashers must be
used. The dispenser must be refilled before the start of each wash cy
-
cle following the instructions provided in the “Programme overview”.
The detergent dispenser is located on the inside panel of the door.
Loading the detergent
•
To open the “ 4 “ cover on the dispenser, press the “5” button.
•
The detergent for the wash cycle should be poured into the “6“
compartment.
•
The detergent for the pre-wash cycle should be poured into the
“7” compartment.
•
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks in place.
Notice:
To facilitate closing the cover, remove any excess detergent on the edges of the
dispenser.