Filter
Top Products
2. Remove the hole cover from the upper left side of door.
Remove the upper hinge block from right side of door.
Replace upper hinge block on the left side of door.
Replace the hole cover to the hole on the right.
3. Remove lower right hinge cover
Loosen and remove the screws that hold the lower right hinge in place
Remove the doorstopper on the bottom left and replace them on the bottom
right (where hinge was just removed).
Unscrew and move pin from right side position on hinge to left side position on
hinge. (Requires 9/32" hex socket.)
Place lower hinge removed from lower right to lower left side and fasten
in place with the screws.
Replace lower hinge cover.
4. Lay door down on a sturdy surface
Remove door seal (gasket) from rear side on door
Note: Do not use sharp instrument (knife, etc.).
Remove hole covers on right front side of door.
Use Phillips screwdriver to remove the two (2) screws that hold the door handle
in place on left side.
Note: Do not lose washer.
Place 1st screw through top hole on right side and screw into handle.
(Do not tighten completely at this time.)
Place 2nd screw through bottom hole and screw into handle and tighten.
Now tighten the 1st (upper) screw completely.
Replace hole cover previously removed into the open holes on left front
side of door.
5. Take door in hand and place bottom left hole in door over bottom left hinge pin
and put into place.
Note: Make sure you hold door to prevent it from falling or
being damaged.
Take previously removed upper hinge and place it in upper left hole of door.
Take screws and tighten upper hinge to cabinet of unit.
Note: Make sure door is level and closes properly (no gaps).
If it does not, loosen upper hinge screws slightly and adjust door and
retighten. Do this until door is level and closes properly.
Replace hinge cover and tighten with screw. Replace screw cover.
10
English
13
16
15
14
12
1
6
12
13
14
15