Filter
Top Products
7
How to Use Single-Serve Side –
Brewing Coffee Grounds or Soft Pods
w CAUTION
Burn Hazard.
To avoid contact with hot coffee or water:
• DO NOT use more than 10 oz. (296 ml) of water for single-serve pack or 14 oz. (414 ml) for grounds. Too much water causes ERR message
and long beep. SOLUTION: Place carafe on warming plate. Turn brew selector dial to Carafe (
). Press l/O button to remove water. Turn
brew selector dial to single-serve side ( ). Add correct amount of water to water reservoir. Start brew process.
• Fill reservoir with cup or travel mug of water into which the coffee will be brewed.
• Fully insert cup or travel mug under brew basket.
• Remove single-serve pack holder before adding coffee grounds to brew basket.
• To avoid overflow, keep ground coffee below MAX fill line.
This unit can be used with
Melitta
®
†
soft pods, available
in the coffee aisle of your local
grocery store.
NOTE: It can take up to 2
minutes before brewed coffee
starts dispensing into your cup or
travel mug.
32
To remove single-serve pack
holder, grasp the single-serve
pack holder cup; slide towards
the back and then lift out.
w CAUTION
Cut Hazard:
Removable single-serve pack
holder has a sharp blade. Handle
with care.
Plug in coffee maker. Rotate brew
selector dial to the right to select
Single-Serve ( ). Press BREW
OPTIONS button to select GROUND
mode.
Fill reservoir with cup or travel
mug into which the coffee will be
brewed (maximum 14 oz. [414 ml]
water).
1
Melitta is a registered trademark of Melitta Haushaltsprodukte GmbH & CoKG. Use of the Melitta trademark
does not imply any affiliation with or endorsement by Melitta Haushaltsprodukte GmbH & CoKG.
†