Filter
Top Products
10
Troubleshooting
POSSIBLE PROBLEM
Machine will not work
when switched “ON.”
Motor appears to stall
when juicing.
Excess pulp building up
in the Micro Mesh
strainer basket.
Pulp is too wet and
insufficient juice is
produced.
Juice sprays out of spout.
Juice drips out of spout
immediately after juicing.
Machine vibrates
excessively.
EASY SOLUTION
The Locking Latches may not be correctly
engaged. Check to see if the Locking Latches
are properly positioned in the two grooves on
either side of the Juice Cover. Refer to pages
5 and 6, Steps 4 and 5.
The juicing action may be too vigorous. Try
slower juicing action by pushing the Food
Pusher down more slowly. Refer to page 7,
Step 4.
Wet pulp can build up under the Juicer Cover
or Pulp Container. Turn unit OFF and unplug.
Empty the Pulp Bin then clean Juice Cover
and Strainer Basket.
Turn OFF and unplug. Remove strainer basket
and clean mesh walls with a fine brush. This
will remove excess fiber build-up which could
be inhibiting the juice flow. Refer to pages 8
and 9.
Try a slower juicing action.
Turn OFF and unplug. Remove strainer basket
and clean mesh walls with a fine brush. This
will remove excess fiber build-up which could
be inhibiting the juice flow. Refer to pages 8
and 9.
Try a slower juicing action by pushing the
Food Pusher down more slowly. Refer to
page 7, Step 4.
With motor ON, raise and lower Food Pusher in
Feed Chute several times. The action forces
remaining pulp and juice out of Strainer Bowl.
Build up of pulp in mesh of strainer basket.
Turn unit OFF and unplug. Clean strainer bas-
ket. Refer to page 9. After cleaning, if machine
vibration continues this could be a sign of a
damaged Strainer Basket. Call our toll-free
Customer Service number to order a new
Strainer Basket.
840148101 ENv02.qxd 4/14/08 11:12 AM Page 10