Filter
Top Products
TRANSMITTER/BATTERY CHARGER ASSEMBLY
1. Attach Antenna (14) by threading it into the top of the Transmitter/Battery Charger (15).
See Figure 5.
2. Note how the Female Battery Connector (3B) connects to the Transmitter/Battery Charger (15)
in order to recharge. See Figure 5.
Figure 5
Figure 6
3. Remove Transmitter Battery Compartment Cover (16) from the bottom of the Transmitter and
insert 6-AA Batteries being careful as to positive and negative positioning. See Figure 6.
BASIC OPERATION
Controls: This Airplane is intended for straight, level flight while allowing turns to the left and right
using the Throttle Control buttons. When ready for flight, turn the Transmitter Power Switch to ON
(see Figure 7). To apply thrust, press down the Throttle Control button (see Figure 7). To increase
speed, keep the Throttle Control button pressed and move Throttle Direction Control forward; to
decrease speed, move it back and lessen pressure on Throttle Control button. (see Figure 7).
Turning: Ease the Throttle Dirrection Control (Figure 7) to the left and the Airplane will turn to the
left. Ease the Throttle Direction Control to the right and the Airplane will turn to the right.
Trim: Use gentle pressure on the trailing edge of the main wing or tail to bend slightly. If one should
break accidentally, a simple fix is a small piece of clear tape. Trim just enough to insure a level,
smooth flight.
Always turn off the Transmitter when done flying.
SKU 95149 - For technical questions, please call 1-800-444-3353. Page 6