Filter
Top Products
SKU 99598/99599 For technical questions, please call 1-800-444-3353. Page 6
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
CLEANING
Read the ENTIRE IMPORTANT
SAFEGUARDS section at
the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION OR ELECTRIC
SHOCK:
Before cleaning appliance,
make sure the appliance’s
switch is turned off, the cord
is unplugged, and the unit has
cooled completely.
Do not immerse motor/heating
element, cord, or plug in water
or any other liquid.
To prevent foodborne illness, wash 1.
the non-electrical parts of the unit be-
fore assembly in warm, soapy water,
taking care to rinse completely.
Dry with a soft cloth. Wipe the motor/2.
heating element housing with a soft
clean cloth or sponge.
Allow unit to dry completely before 3.
assembly or use.
After washing and drying, apply a 4.
small amount of salad oil (not includ-
ed) to Cutting Plates to keep them
lubricated.
WARNING!5. Do not use bleach, thin-
ners or benzines during clean. These
will damage or discolor Meat Grinder.
ASSEMBLY
(FOR 99598 MEAT GRINDER)
Read the ENTIRE IMPORTANT
SAFEGUARDS section at
the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION OR ELECTRIC
SHOCK:
Before appliance assembly or
adjustment, make sure the
appliance’s switch is turned
off, the cord is unplugged,
and the unit has cooled
completely.
Note: For additional information regarding
the parts listed in the following pages,
refer to the 99598 Assembly Diagram
on pages 10 and 11 of this manual.
Slide Head (12) into Housing Open-1.
ing (15). While holding Head, place
Locking Knob (22) into slot on Left
Motor Housing (21).
Turn Locking Knob clockwise until 2.
tight and Head is fastened securely to
housing.
Twist Feed Screw (100) long-end 3.
rst into Head. Continue twisting until
Feed Screw fastened into housing.