Filter
Top Products
SKU 99598/99599 For technical questions, please call 1-800-444-3353. Page 9
If the Grinder gets jammed, the over-9.
load light will ash and the beep-beep
alarm will sound.
When jammed, the Circuit Breaker 10.
(26) will trigger. Once jam is cleared
(Inspection And Maintenance), reset
Circuit Breaker switch.
To make sausage, insert desired 11.
Sausage Maker (3, 4, or 5) into Sau-
sage Adapter (2).
Place wide end of Sausage Adapter 12.
against the Head and in front of Cut-
ting Blade.
Slide Cap over Sausage Maker and 13.
Adapter and turn clockwise until Sau-
sage Adapter is fastened securely
against housing. CAUTION! Do not
overtighten.
For making Kubbe, place Kubbe At-14.
tachments (9, 10) onto Feed Screw
shaft. Slide down until the Attach-
ment tabs t into the slots.
Slide Cap over Attachments and turn 15.
clockwise until fastened securely
against housing. CAUTION! Do not
overtighten.
INSPECTION AND
MAINTENANCE
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION OR ELECTRIC
SHOCK:
Before appliance inspection
or maintenance, make sure
the appliance’s switch is
turned off, the cord is
unplugged, and the unit has
cooled completely.
TO PREVENT SERIOUS
INJURY FROM APPLIANCE
FAILURE:
Do not use damaged
appliances. If abnormal
noise or vibration occurs,
have the problem corrected
before further use.
BEFORE EACH USE,1. inspect the
general condition of the appliance.
Check for loose screws, misalignment
or binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
To clear jams, switch off Grinder and 2.
remove power cord from outlet.
Unscrew Cap and remove Cutting 3.
Plate. CAUTION! Use screwdriver
(not included) to remove Cutting
Plate from Head. Do not remove with
ngers.
Remove clogged meat, wash parts 4.
in warm, soapy water, dry and reas-
semble.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS
PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER
THE MANUFACTURER OR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO
THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE
ANY REPAIRS TO THE PRODUCT, OR THAT HE OR
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT
BY THE BUYER. THE BUYER ASSUMES ALL RISK AND
LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.