Filter
Top Products
12-02 11 34615 Rev G
NOVUS B-VENT INSTALLATION INSTRUCTIONS
F. UTILITIES
Figure 12 - Flexible Connector and Manual
Shutoff Valve
Note: The appliance and its manual shutoff valve must
be disconnected from the gas supply piping system dur-
ing any pressure testing of that system at test pressures
in excess of 1/2 psi (3.5 kPa). The appliance must be
isolated from the gas supply piping system by closing its
manual shutoff valve during any pressure testing of the
gas supply piping system at test pressures equal to or
less than 1/2 psi (3.5 kPa).
Figure 13 - Gas Line
3. GAS PRESSURE
On the standing pilot gas control valve and the
electronic valve, a pressure tap is included on the front
face of the valve.
Table 2 shows optimum gas pressure information.
Consult your local gas company for assistance in
determining the proper orifice for your altitude or refer
to ANSI Z223.1-latest edition, Appendix F.
4. FUEL
Do not burn wood or other material in this appliance.
Natural or propane gas conversions necessary to meet
the application need to be made by a qualified
technician using Hearth & Home Technologies
specified and approved parts.
In the event your standing pilot appliance must be
converted to use propane gas, you must use a CKVP
conversion kit. To convert to use natural gas, you must
use a CKVN conversion kit.
If your intermittent pilot appliance must be converted
to use natural gas, you must use a DCKN conversion
kit. To convert to propane, use a DCKP conversion Kit.
TABLE 2
1. HIGH ALTITUDE INSTALLATION
For U.S. installation, appliances are tested and
approved for elevations from 0-2000 feet. When
installing this appliance at an elevation above 2000
feet, National Fuel Gas Codes require a decrease of
the input rating by changing the existing burner orifice
to a smaller size. Input should be reduced 4% for each
1000 feet above sea level. Check with the local gas
utility for proper orifice size identification. Orifices are
available from your distributor.
For Canada, appliances are certified for elevations from
0-4500 feet. When installing this appliance at an
elevation between 0-4500 feet in Canada, the input
rating does not need to be reduced. When installing
this appliance at an elevation above 4500 feet in
Canada, check with local authorities.
2. GAS LINE CONNECTION
The appliance is provided with a stainless steel flexible
connector and manual shutoff valve. See Figure 12.
The incoming gas line should be piped into the valve
compartment and connected to the 1/2 FIP connection
provided on the manual shutoff valve. See Figure 13.
All connections must be tightened and checked for
leaks with a soap and water solution or leak detector.
Bleed the gas line to extract any air that may have
been trapped inside the pipe.
SUVON
.G.N-erusserpylppuSsagtelnI*).xaM(0.7-).niM(5.4
.G.N-erusserpdlofinaMmumitpO*5.3
.P.L-erusserpylppuSsaGtelnI*).xaM(0.41-).niM(0.11
.P.L-erusserpdlofinaMmumitpO*0.01
.G.N-etaRtupnI03CBNG.rh/UTB000,52
33CBNG.rh/UTB000,52
63CBNG.rh/UTB000,72
.P.L-etaRtupnI63/33CBNG.rh/UTB000,52
03CBNG.rh/UTB000,42
.G.N-eziSecifirO63CBNGmm65.2/.ni101.
33/03CBNGmm34.2/.ni690.
.P.L-eziSecifirO63/33/03CBNGmm05.1/.ni950.
nmulocretaw/sehcni*
WARNING!
This valve has been preset at the factory. Altering
settings may result in fire hazard or bodily injury.