Filter
Top Products
Model 290
1-4. ERROR CODES (Continued)
CE Only - Along with the error codes from page 1-11, CE
units have the following self-diagnostic error codes:
DISPLAY CAUSE PANEL BOARD CORRECTION
“E10” High limit Reset the high limit by manually pushing up on the red reset
button; if the high limit does not reset, the high limit must be
replaced per the High Limt Temperature Control Section
“E15” Drain Switch Close the drain, using the drain valve handle; if display still
shows “E-15”, check the drain microswitch per the Drain
Switch Section
1103 1-12