Filter
Top Products
1-7. SLOT COVER
When installing the computerized panel retrofit kit, it is necessary
to cover the existing slot in the heat shroud. This slot allows the
capillary tube of the old control panel to extend through the heat
shroud when mounting the old control.
A. Open door and push slot cover through shroud from bottom
of the shroud.
B. Bend the 4 tabs of slot cover over the top of the heat shroud.
1-8. CONTROL PANEL
INSTALLATION
A. The new computerized panel is positioned and installed exactly
like the existing electromechanical control panel.
B. Place the computerized control panel on top of fryer frame
and door.
C. Mate the nine-pin connectors together. Refer to KFC gas
wiring diagram.
D. Connect the temperature probe to the control panel board.
E. Install the control panel and two screws. When installed
properly there will be approximately a 7/16 inch of a gap
between the bottom of the control panel and fryer rail.
F. This completes the electrical and mechanical installation of
the computerized control panel.
1-4 304