Filter
Top Products
Model OFE/OFG/OEA/OGA-341, 342
3-12. CHANGING THE FILTER
ENVELOPE (Continued) 11. Fold the corners in and then double fold the open end.
12. Clamp the envelope in place with the two filter
retaining clips.
13. Replace the crumb catcher screen on top of the filter
paper. Screw on the suction standpipe assembly.
14. Place complete filter screen assembly back into filter
drain pan, replace cover, and slide pan back into place
beneath the fryer.
15. Connect the filter union by hand. Do not use a wrench.
16. The fryer is now ready to operate.
3-13. CLEANING After the initial installation of the fryer, as well as before
THE FRYPOT(S) every change of shortening, the frypot should be thoroughly
cleaned as follows:
1. Turn the main power switch off.
The filter drain pan must be as far back under fryer as it
will go, and the cover in place. Be sure the hole in the
cover lines up with the drain before opening the drain.
Failure to follow these instructions causes splashing of
shortening and could result in personal injury.
Moving the fryer or filter drain pan while containing hot
shortening is not recommended. Hot shortening can
splash out and severe burns could result.
Always wear chemical splash goggles or face shield and
protective rubber gloves when cleaning the frypot as the
cleaning solution is high in alkaline. Avoid splashing or
other contact of the solution with your eyes or skins.
Severe burns may result. Carefully read the instructions
on the cleaner. If the solution comes in contact with
your eyes rinse thoroughly with cool water and see a
physician immediately.
2. If hot shortening is present in the frypot, drain it by
slowly opening the drain valve handle, one half turn.
Leave for a few minutes, then slowly open the valve
to full open position.
3-18 903