Filter
Top Products
Hickory Industries, Inc.
4900 Westside Avenue, North Bergen, New Jersey 07047
Tel: [201] 223-0050 Fax: [201] 223-0950
N/45 Series Manual12/00
Page 33 of 38
6. Loading and Unloading Spits
On the N/45G, you do not need to open the front sliding glass doors of the machine in order to
load the spits! If your unit is equipped with hinged side doors, these must be opened in order to
insert and/or remove the spits. With the side(s) open, use a barbecue fork to grab a spit on one end,
inside the single skewers. You can then use your free hand to hold the spit handle. With the motor
switch on or off, first insert the round end of the spit and position it on the oil lite bushing on the
center plate (see Figure 27). Then position the
spit gear (next to the handle) so that it meshes with
the
shaft worm on the vertical drive shaft. Shift the spit from side to side so that the space formed
between the
spit collar and the spit gear fits fits (falls) onto the oil lite bushing on the spit plate.
Reverse procedure to unload.
Figure 27
Figure 28
Spit Collar
Oil Lite Bushing
Shaft Worm
Spit Gear
Spit Plate