Filter
Top Products
Hickory Industries, Inc.
4900 Westside Avenue, North Bergen, New Jersey 07047
Tel: [201] 223-0050 Fax: [201] 223-0950
N/45 Series Manual12/00
Page 35 of 38
At The End of Each Day
Turn burners valves or element switches to the “OFF” position and allow the oven to cool down.
Remove any spits or baskets – allow them to soak for 15 – 20 minutes, using a solution of warm
water and detergent. Rinse clean, following guidelines for rinsing & sanitizing.
Remove the wire rack – and clean it in the sink using a solution of warm water and detergent.
Drain the greasy water from the drip pan and replenish with a solution of warm water and detergent.
Using either a sponge or a cloth - wipe down the interior of the oven with the solution removing any
grease/fat. Wipe dry the interior of the oven with a soft cloth.
USE CARE WHEN CLEANING NEAR THE PILOT ASSEMBLY. IF YOU ACCIDENTALLY
MOVE THE THERMOCOUPLE, BE SURE THAT YOU SNAP IT BACK INTO POSITION.
Drain the solution from the drip pan, wipe clean and return to the oven along with the wire rack.
Clean the glass with an approved glass cleaner. Do not use abrasives or razor blades as they will
mar and/or scratch the surface causing it to break without notice.
Wipe clean the area around the controls with a sponge or soft cloth.
GAS MODELS
RE-LIGHT THE PILOTS AND TURN ON ALL BURNERS (SET TO HIGH).
ELECTRIC MODELS
TURN ON ALL OF THE ELEMENTS.
RUN THE UNIT FOR APPROXIMATELY 5 MINUTES TO BURN OFF ANY CHEMICAL
RESIDUE THAT MAY BE REMAINING FROM THE CLEANING PROCEDURE.
Recommendation – now would be a good time to spray the interior of the oven with KOTE. You
will be prepared for tomorrow’s cooking cycle.
NOTE: On a monthly basis, to ensure that the burner is operating efficiently, remove the
ceramics and use a paper clip to clean any debris from the burner openings. Additionally the
venturi air inlet gap needs to be cleaned. This can be done using a paring knife or business
card. Refer to the operating manual.