Filter
Top Products
18
DEFROST
AND
TEMP CONTROL
The O5DMA uses timed off defrost as
its primary defrost method. The timed-off
defrost termination control probe is located in
the middle fo the coil near the top as shown in
the diagram below. Access to the probe can
be gained by removing the lower rear baffle.
The temperature control probe is located
behind the 3 1/2” plug button in the top flue
panel, also shown in the diagram below. Both of
these probes are wired to the case controller
mounted on top of the case.
Timed-Off defrost termination control
probe location (In center of coil near
top of coil).
Temperature control probe location
(Behind the 3 1/2” plug button).