Filter
Top Products
– 3 –
INSTALLATION
UNPACKING
Immediately after unpacking the slicer, check it for possible shipping damage. If this machine is found
to be damaged, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installing the slicer, test the electrical service to assure it agrees with the specifications on the
machine data plate.
ASSEMBLY
The container of oil marked Lubriplate FM0-200-AW is for machine lubrication. Refer to
LUBRICATION,
page 8.
Remove the carriage tray from its shipping location, place it in position on the carriage support (Fig.1),
and secure it by tightening the thumb screw. The two washers must be on the bottom, next to the thumb
screw, to fit properly.
Locate the knife sharpener, packed loose in the shipping carton, and store it in a location where you
can find it when the knife needs sharpening. Refer to KNIFE SHARPENING, pages 6 – 7.
Fig. 1
ELECTRICAL
WARNING: THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE
OUTLET TO WHICH THIS PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE
RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN.
CLEAN BEFORE USING
This slicer must be thoroughly cleaned and sanitized after installation and before being used. Refer
to CLEANING, pages 5 – 6.
PL-40617-1
Meat Grip
Thumb Screw
Carriage Tray
Carriage Support