Filter
Top Products
– 7 –
PRESET VALUES — U.S. WEIGHT UNITS
Six preset values for each weigh mode and slice count are available. The preset values provided at
the factory for U.S. weight units are shown in the table below. Other values can be programmed in
place of these values by following the Programming instructions in the next section.
FACTORY PRESET VALUES — U.S. WEIGHT UNITS
MODE Preset 1 Preset 2 Preset 3 Preset 4 Preset 5 Preset 6
WEIGH — LB 0.25 0.50 0.75 1.00 1.50 2.00
WEIGH — OZ 2.0 4.0 6.0 8.0 10.0 12.0
SLICE COUNT 4 6 8 10 15 20
PROGRAMMING
To enter Program Mode with slicer controls lit and lever on Automatic: Hold down the Mode key for
6 seconds until 2 beeps sound and [Prog] displays for 2 seconds. Release the Mode key. The blinking
PRESET indicates Program Mode. The CARRIAGE SPEED light(s) and the WEIGH (LB or OZ) or COUNT
indicator lights show which Preset value is displayed. There are six preset values for each of the three
categories (eighteen total). Do not interrupt power during programming.
1. Press the Mode key to select
COUNT or WEIGH Mode. In WEIGH Mode, press both Mode and Up
arrow keys at the same time to weigh in
LB units; or, press Mode and Down arrow keys at the same
time to select
OZ units.
2. Press the Up and Down arrow keys to increase or decrease the Preset value.
3. Press Hare or Tortoise keys to access any Preset value (1 – 6) indicated by the
CARRIAGE SPEED
lights for the indicated category.
Repeat steps 1, 2, and 3 to review or change any of the 6 Preset values for any of the 3 categories
(18 preset values in all). When all Preset values are programmed as desired, press the Mode key for
2 seconds to Save and Exit. A beep sounds. [ If 0 is programmed as a Preset value, the slicer will Count
Up until slicing is stopped by the operator.]
CAPACITY
The scale weighs according to the following capacity limits:
U.S. Pounds U.S. Ounces Kilograms Grams
6 lb by .01 lb increment 96 oz by 0.1 oz increment 3 kg by .005 kg increment 3000 gm by 5 gm increments
SLICE AND WEIGH MORE THAN ONE ITEM
After slicing an item in weight mode, press Tare to set the weight back to zero without removing the
sliced product from the platter. Then, with the scale display at 0.00 lb, slice and weigh the next item.
PRESET VALUES — METRIC WEIGHT UNITS ONLY
The six preset values for each weigh mode and slice count provided at the factory for metric weight units
are shown in the table below. Other values can be programmed in place of these values by following
the Programming instructions in the previous section.
FACTORY PRESET VALUES — METRIC WEIGHT UNITS
MODE Preset 1 Preset 2 Preset 3 Preset 4 Preset 5 Preset 6
WEIGH — kg 0.100 0.200 0.300 0.400 0.500 1.000
WEIGH — gm 100. 200. 300. 400. 500. 1000.
SLICE COUNT 4 6 8 10 15 20