Filter
Top Products
510/512 INSTRUCTIONS
Fig.
1
Instructions
for
Operation and Care
of
MODELS 510 AND 512 MEAT SLICERS
1. INSTALLATION:
When the machine is packed for shipment, the
three rubber feet (6, Fig. 1) and the one helper
foot (7, Fig. 1) are removed and sent along in a
cloth bag. The feet can be readily reassembled.
Install the helper foot to the end of its thread at
the comer of the base as shown (7, Fig.
1.
The
helper foot does not touch the counter or table
and prevents the slicer from tipping.
In ordinary service, it will not be necessary to
fasten the slicer down; the cup-shaped rubber feet
will prevent it from slipping on the table. For
mounting on shipboard, discard the feet, and bolt
slicer to the table with 5116"-18 cap screws.
If cord and plug is not used with this machine,
electrical connections should be made by qualified
workmen who will observe all applicable Safety
Codes and the National
EIectrical Code.
Before making electrical connections, CHECK
THE SPECIFICATIONS ON THE NAME
PLATE
(3,
Fig.
l),
TO MAKE SURE THEY
AGREE
WITH THOSE OF YOUR ELECTRlCAL
SERVICE.