Filter
Top Products
– 4 –
PL-40786-1
Upper Pulley
Pulley Latch
Slot for Tongue of Table
Table Rests (1 of 4 )
Upper Pulley Wiper
Left Carriage Stop
Lower Guide and Wiper
Upper Guide
and Guard
LOWER GUIDE AND WIPER ASSEMBLY
The lower guide and wiper assembly fits in the slideway
of the wiper bracket (Fig. 3). The blade fits in the slots
of both the steel guide and the nylon guard. Wipers fit
on both sides of the blade. This assembly includes a
wiper for wiping the lower pulley during use.
TABLE
In use, the table is aligned and supported by the
locator block (Fig. 3) and four table rests (Fig. 4)
fastened to the machine base. When aligned properly,
the table is secured to the base when the tongue of the
table is inserted in its slot (Fig. 4) and the table clamp
is latched down (Fig. 5).
To remove the table, raise the gauge plate to its
vertical position. Release the table clamp on the left
side. Shift the table to the left, freeing the tongue from
its slot. Lift table by its front side to remove.
Fig. 3
To reinstall the table, tilt the front side of the table up so the rectangular hole on the rear side goes
around the base of the column. Lower the table to the base. Raise the left end of the table and slide
it to the right so the tongue on the right side fits in its slot. Lower the left end of the table. Align so the
pins of the table rests are outside of the table support angles. The rectangular hole in the front table
support angle straddles the locator block. When the table is in proper position, latch the table rod with
the table clamp (Fig. 5).
Fig. 4 Fig. 5
PL-40790-1
Nylon Guard
Blade Guide
Locator Block
Lower Pulley Wiper
Wipers
Blade
Slideway - Wiper Bracket
Lower Guide
and Wiper
PL-40787-1
Switch Knob
Carriage Guide
Carriage
Carriage Lock
Motor Access Panel
Table Clamp
Data Plate