Filter
Top Products
– 4 –
PL-41423-1
BOWL COVER
BOWL COVER GASKET
ALIGMENT PIN
LIP
LID PLUG
PL-41421-1
ARM
MOTOR SHAFT
KNIFE SHAFT
BOWL
BOWL
HANDLE
BOWL PIN
SLOT
BOWL AND KNIFE ASSEMBLY
Install the Bowl so the center post of the Bowl fits
over the motor shaft, one of the Bowl Pins fits in
the slot at the front of the machine, and the bowl
handles are positioned on left and right (Fig. 1).
Install Knife Shaft over center bowl post so the
slots on the Knife Shaft fit the grooves on the
motor shaft (Fig. 1).
Fig. 1
The four Bowl Scraper Wipers must be properly
installed in the grooves of the Bowl Scraper. The
upper tips of the wipers point straight up and
slightly toward the center (Fig. 2); the ends of the
wipers are vertical so they do not interfere with
the lip of the Bowl Cover. Do not install the
wipers backwards.
Fig. 2
After installing the Lid Plug, turn it so the
underneath side of the plug is flat with the
underneath side of the Bowl Cover (Fig. 3). The
Bowl Cover Gasket must be properly installed in
the groove around the lip of the Bowl Cover
(Fig. 3).
Fig. 3
PL-41422-1
BOWL SCRAPER
END
TIP
WIPER