Filter
Top Products
– 7 –
PREPARING THE PRODUCT FOR PROCESSING
Cut products such as meat and cheese into equal pieces of approximately 1" cubes for easy
processing.
For bread crumbs or other dry products, place product into the bowl first, turn the machine on, then add
liquid ingredients.
For pureeing products, be sure to move the Scraper Handle back and forth to reintroduce partially cut
product into the cutting zone.
USING THE BOWL SCRAPER DURING PROCESSING
During processing, move the Scraper Handle back and forth to reintroduce partially cut product that
is clinging to the sides of the bowl back into the cutting area. The Bowl Scraper can also be used during
processing to stir or mix liquid products. The Bowl Scraper has four legs and four lid wipers — this
allows a 90° motion to fully wipe the entire Bowl and lid.
USE OF THE FEED TUBE
The Bowl Cover is equipped with a Lid Plug which can be pulled open for adding ingredients. When
replacing the Lid Plug, be sure to turn the Lid Plug so the underneath side of the plug is flat with the
underneath side of the Bowl Cover. With the Lid Plug in closed position, the Scraper Handle should
move back and forth over it.
CLEANING
WARNING: SWITCH OFF AND UNPLUG MACHINE POWER CORD BEFORE BEGINNING ANY
CLEANING PROCEDURE.
The food processor should be thoroughly cleaned after use.
Never use steel wool, abrasive cleaning sponges, or high pressure
hose for cleaning. Do not leave the knife shaft wet or setting on
a stainless steel worktop when not in use.
Swing the Arm to the rear as far as it will go. Remove the Bowl
Cover / Bowl Scraper / Scraper Handle by lifting straight up, out
of the Bowl. Set the assembly on a table or countertop (Fig. 8).
Press the Scraper Handle down (Fig. 8), freeing the tabs of the
Scraper Handle Shaft from the slot restrictions in the Bowl
Scraper. While pressing down, turn the Scraper Handle
counterclockwise
1
/8 turn. Remove the Scraper Handle. Separate
the Bowl Cover and Bowl Scraper. Remove the Bowl Scraper
Wipers from the grooves of the Bowl Scraper.
Remove the Knife Shaft by lifting it straight up. Remove the
Bowl.
Remove the Bowl Cover Gasket from the Bowl Cover by grasping
the gasket with your finger and thumb at the Indentation where
the Gasket Groove is not present (Fig. 9).
Wash, rinse, and sanitize all parts in a sink as you would any food
utensil and allow to air dry. Wipe the exterior of the machine with
a damp cloth. Reassemble all parts when dry following the Bowl
and Knife Assembly instructions on pages 4 – 5.
PL-41428-1
INDENTATION
GASKET GROOVE
Fig. 8
PL-41425-2
PRESS HANDLE DOWN
THEN TURN
COUNTERCLOCKWISE
1/8 TURN
TO RELEASE
Fig. 9